X10 Powerline Command Repeater (PLC01)

Make sure your X10 powerline signals get to their destinations reliably by adding the X10 Powerline Command Repeater to your system. The module simply plugs into an outlet and immediately begins repeating any X10 signals that pass through it over the powerline, extending signal range.Repeats X10 powerline signals to extend rangePlugs into any standard power outletBuilt-in outlet on bottom for other plug-insBecause the X10 Powerline Command Repeater plugs into an outlet, it features a built-in pass-through outlet at the bottom (not X10 controlled), so you don’t lose a power outlet. The repeater should be installed in the approximate center between your X10 RF transmitters and receivers.NOTE: The outlet on the bottom of the module is not X10 controlled. It serves as a traditional pass-through power outlet only.Technical DetailsMPN: PLC01Color: WhiteControl: Active repeating of X10 powerline commandsPower Requirements: 120 VAC, 60Hz, 5AEnvironmental Conditions: Indoor use onlyDimensions: 2.94(L) x 2.06(W) x 1.3(D) inchesWarranty: 2 Years

• Repeats X10 powerline signals to extend remote control range
• Plugs into any standard power outlet
• Built-in outlet on bottom for other plug-ins